Implementing Cisco IP Telephony amp; Video, Part 1 v1.0
Question No: 61
A phone is assigned to a partition that is included in the CSS HQ-Phone. This partition contains a route pattern to block calls to service numbers 1-400-xxx-xxxx. When the
engineer makes a test call to the number 1-400-400-9000 from that phone, the call goes through. What is the reason for
The route pattern for the number to be blocked is in partition not accessible to the CSS.
The correct route list is not selected in the route pattern for the dialed number to be blocked.
The correct gateway is not selected for the route list for the route pattern for the dialed number to be blocked.
The route pattern for the number to be blocked is in “NULL” partition.
The route pattern is misconfigured.
Question No: 62
Refer to the exhibit.
When a user dials 919005551212, the call fails. Which change do you need to make for this call to be successful?
Change the route partition.
Change the gateway or route list.
Change the route pattern to the correct number of digits.
Change the call classification to OnNet.
Change the route option.
Question No: 63
What are the two benefits of using SIP dial rules on an IP phone? (Choose two)
The phone can initiate dialing without sending any signaling messages to Cisco Unified CommunicationsManager.
The phone can detect invalid numbers and play a reorder tone without sending any signaling messages toCisco Unified Communications Manager.
If dialed digits match an entry of a SIP dial rule, the dialed string is sent in a single SIP
200 OK message toCisco Unified Communications Manager.
If Cisco Unified Communications Manager requires more digits, KPML can be used to send the remainingdigits from the SIP phone to Cisco Unified Communications Manager one-by-one.
If Cisco Unified Communications Manager requires more digits, another en bloc message is used to sendthe remaining digits from the SIP.
Question No: 64
Refer to the exhibit.
To reach an external number, a user first dials a 9. Which route pattern will be matched if a user dials an international number 011442288223001 and terminates the interdigit timeout?
Question No: 65
Which three of these are characteristics of a Cisco Unified Communications Manager software- based Media Termination Point? (Choose three.)
The codec and packetization of both call legs must be identical.
This Media Termination Point type does not require any DSP resources on the Cisco router.
DSP resources are required.
It can provide G.711 mu-law to G.711 a-law conversion and vice versa.
It can provide packetization conversion for a given codec (for example, if one call leg is using a 20-mssampe size, but the other call legis using a 30-ms sample size).
This Media Termination Point type is typically used for RSVP agent configurations or Cisco Unified borderelementmedia flow-through configuration.
Question No: 66
Route lists determine the order of preference for route group usage. If a route list is configured, what is the minimum number of route groups that you must configure?
Question No: 67
What is the default option for framing when you configure T1 controller?
alternate mark inversion
C.Extended Super Frame
D.cyclic redundancy check 4
E.high-density bipolar 3
G.binary 8-zero substitution
Question No: 68
Refer to the exhibit and configuration output.
What are the two main ways from New York to call Extension 6001 in England? (Choose two.)
sh run | s Dial-peer dial-peer voice 2 voip destination-pattern 6… preference 0
session-target ipv4: 126.96.36.199
dtmf-relay sip-notify dial-peer voice 3 pots destination-pattern 6…
preference 1 port 0/0/0:23 prefix 757385
The first way is WAN.
The first way is PSTN.
The second way is WAN.
The second way is PSTN.
Question No: 69
Refer to the exhibit.
To reach an external number, a user first dials a 9. Which route pattern will be matched if a user dials the toll-free number 18005550123?
Question No: 70
Which groups will have access to the Meet-Me conference numbers that are set to use the
Only users that have the lt;Nonegt; partition assigned in their calling search space will have access to the Meet-Me conference numbers.
All users will have access to the Meet-Me conference numbers.
The lt;Nonegt; partition will prevent all users from accessing the Meet-Me conference numbers.
Any IP phones with their lines configured in the lt;Nonegt; partition will have access to the Meet-Me conference numbers.
|Lowest Price Guarantee||Yes||No||No|
|Free VCE Simulator||Yes||No||No|