Designing Cisco Data Center Unified Computing
Question No: 221 – (Topic 2)
You plan to extend a single-site data center to a dual-site solution that will use an IP-based Layer 3 interconnect using Cisco Nexus switches. The solution must support virtual machine migrations between the two sites. Which protocol must you use?
B. VPLS C. OTV D. BGP
Question No: 222 – (Topic 2)
When migrating an existing data center network to a unified fabric network, which transitions should you expect to see?
IOS to Nexus networking equipment
physical to virtual machines
Fibre Chanel to FCoE
iSCSI to NAS
Question No: 223 – (Topic 2)
You are designing the aggregation layer for a data center that will use Cisco Nexus 5000 Series Switches. The data center will have more than 500 Fibre Channel domains. Which configuration is required for the design?
Access switches must be in N Port proxy mode.
Access switches must be in N Port mode.
The SAM director switch must be installed and configured.
DCNM for SAN must be installed and configured.
Question No: 224 – (Topic 2)
Which three characteristics are associated with the access layer of a Data Center Unified Fabric network? (Choose three.)
no packet manipulation
voice, data, and wireless convergence
scalable routing protocols like OSPF
provides default gateway redundancy
QoS – classification and queuing
routing manipulation and filtering
aggregates end users
Question No: 225 – (Topic 2)
Which Cisco product meets the LAN extension cryptography requirement in OTV over Dark Fiber scenario?
C. VSG D.
Question No: 226 – (Topic 2)
Which two platforms are supported by using the Cisco Prime Data Center Network Manager?
Cisco MDS switches
Cisco Nexus switches
Question No: 227 – (Topic 2)
Which three protocols are effective in minimizing the use of STP in the data center design?
Question No: 228 – (Topic 2)
From a data center design perspective, which of the following is true in regard to network management tools like Cisco Data Center Network Manager (DCNM) and CiscoWorks LAN Management Solution (LMS)?
Cisco DCNM is positioned to manage non-Nexus OS gear like the Catalyst 6500 Series, Catalyst 6500 Series FWSM, and Cisco UCS.
Platform-specific, advanced data center features should be managed by Cisco DCNM and provided to CiscoWorks LMS.
CiscoWorks LMS should be used to manage the LAN network, while Cisco DCNM will manage the SAN network.
Cisco DCNM should be used to manage everything except the aggregation service layer.
Question No: 229 – (Topic 2)
Which item represents a hardware requirement on the Cisco MDS 9500 Series Director to achieve Fibre Channel connectivity with the Cisco Nexus 7000 Series data center switch? (Choose one.)
Cisco MDS 9000 Family 48-Port 8-Gbps Advanced Fibre Channel Switching Module
Cisco MDS 9000 Family 4-Port 10-Gbps Fibre Channel Switching Module
Cisco MDS 9000 16-Port Storage Services Node
Cisco MDS 9000 10-Gbps 8-Port FCoE Module
Question No: 230 – (Topic 2)
Refer to the exhibit.
How does FabricPath behave if a new spine is added to this network with switch-ID 2504?
Traffic to switch-ID 2504 is load balanced.
The existing switch-ID 2504 is assigned a new switch-ID.
The new spine fails to join FabricPath.
The existing switch-ID 2504 is removed from FabricPath.
|Lowest Price Guarantee||Yes||No||No|
|Free VCE Simulator||Yes||No||No|