[Free] 2019(Nov) EnsurePass Cisco 200-355 Dumps with VCE and PDF 71-80

November 2, 2019

200-355 Dumps 2019-11

, , ,

Get Full Version of the Exam
http://www.EnsurePass.com/200-355.html

Question No.71

Which interface is used to connect the foreign and anchor controllers?

  1. management

  2. service

  3. virtual

  4. dynamic

Correct Answer: A

Question No.72

Refer to the exhibit. A customer is determining whether a Windows 7 laptop is operating on the correct IEEE 802.11 standard. Which standard is being used by the laptop in the exhibit?

image

A. 802.11b B. 802.11g C. 802.11n D. 802.11p

Correct Answer: C

Question No.73

Refer to the exhibit. The wireless engineer has deployed the Cisco 5508 Wireless Controller. The controller is responding on the service port; however, it will not respond on the management interface. Which configuration revision will fix the management interface?

image

  1. On the switch interface, configure switch(config-if)#switchport trunk allowed vlan add 10.

  2. On the WLC management interface, disable LAG on the management network.

  3. On the switch interface, configure switch(config-if)#switchport trunk allowed vlan 10.

  4. On the WLC management interface, change the VLAN ID to 20.

  5. On the switch interface, configure no spanning-tree portfast trunk.

  6. On WLC Controller gt; General, disable LAG and reboot.

Correct Answer: A

Question No.74

Which two attributes must be configured to match in order for WLCs to operate in the same mobility group? (Choose two.)

  1. mobility domain name

  2. virtual IP address

  3. service interface address

  4. hardware model

  5. software version

Correct Answer: AB

Question No.75

An access point is currently transmitting at 4 mW. The customer needs to increase its signal strength by 6 dB to create a larger wireless cell. What should the new transmit power be?

  1. 8 mW

  2. 10 mW

  3. 12 mW

  4. 16 mW

  5. 24 mW

Correct Answer: D

Question No.76

You are designing a wireless network in a medical facility. Which three areas are bad locations in which to install a wireless access point? (Choose three.)

  1. in front of the elevators doors

  2. in the hallways

  3. next to the electrical room

  4. inside offices

  5. near medical imaging devices

  6. in the lobby

Correct Answer: ACE

Question No.77

Which spread spectrum technique uses 11-bit chips to transmit 1 bit of data over a 22-MHz channel?

  1. DSSS

  2. FHSS

  3. OFDM

  4. MIMO

  5. CCK

Correct Answer: A

Question No.78

Refer to the exhibit. A help desk ticket has been entered for the wireless infrastructure. A wireless client is not able to connect at IEEE 802.11n rates. Which option allows for connectivity?

image

  1. Set WMM mode to Optional or Required.

  2. Set Quality of Service (QoS) to Silver.

  3. Set Quality of Service (QoS) to Platinum.

  4. Set 7920 AP CAC to Enabled.

Correct Answer: A

Question No.79

Which two statements best describe the LAG configuration between a Cisco WLC and a Cisco Catalyst switch? (Choose two.)

  1. The Catalyst switch should be configured for PAgP.

  2. The Catalyst switch should be configured only for Layer 2 load balancing.

  3. The Catalyst switch should be configured for quot;onquot; mode.

  4. The Cisco WLC relies on the connected switch to perform the load-balance of traffic.

  5. The Cisco WLC aggregates multiple management interfaces into a single virtual interface.

Correct Answer: CD

Question No.80

Which three items are allowed on an Ethernet trunk port? (Choose three.)

  1. autonomous AP

  2. FlexConnect AP

  3. local AP

  4. monitor AP

  5. rogue detector AP

  6. sniffer AP

  7. SE-Connect AP

  8. Cisco WLC

Correct Answer: ABE

Get Full Version of the Exam
200-355 Dumps
200-355 VCE and PDF

Related Posts