[Free] 2019(Nov) EnsurePass Cisco 400-151 Dumps with VCE and PDF 31-40

Get Full Version of the Exam

Question No.31

Which two statements about the dynamic load balancer mode in ACI are true? (Choose two)

  1. The default DLB mode is quot;conservativequot;

  2. The aggressive DLB mode has a longer flowlet timeout interval

  3. The aggressive mode flowlet timeaut is a relatively higher value

  4. DLB adjusts the traffic allocations according to congestion levels

  5. The aggressive DLB mode has a shorter flowlet timeout interval

Correct Answer: DE

Question No.32

Refer to the exhibit. How many virtual adapters (vNIC and vHBA) can be added to this host?










Correct Answer: C

Question No.33

Which two statements about VLAN Trunking Protocol are true? (Choose two)

  1. VIAN Trunking Protocol is a Layer 2 messaging protocol that maintains VLAN consistency by managing the addition, deletion, and renaming of VLANs within a VLAN Trunking Protocol domain.

  2. On Cisco Nexus switches, VLAN Trunking Protocol is enabled by default.

  3. Layer 2 trunk interfaces, Layer 2 port channels, and virtual port channels support VLAN Trunking Protocol functionality.

  4. VLAN Trunking Protocol is only supported on Layer 2 trunk interfaces.

  5. VLAN Trunking Protocol is a Layer 2 messaging protocol that maintains the interface VLAN configuring within a VLAN Trunking Protocol domain.

Correct Answer: AC

Question No.34

Which three options are prerequisites to enable Intelligent Traffic Director on the Cisco Nexus 7000 series? (Choose three)

  1. feature pbr

  2. feature lldp

  3. feature sla sender

  4. feature vlan

  5. feature interface-vlan

  6. lp sla responder

Correct Answer: ACF

Question No.35

Which two statements about Node Management Address are true? (Choose two)

  1. Static node management addresses support only IPv4 addressing

  2. Static node management addresses, in-band and out-of-band, are associated with the common tenant

  3. Node management addresses are configured during the initial APIC and switch setup scripts, and they are not part of APIC policy configuration

  4. The external management entity instance profile communicates with nodes that are part of out-of- band management endpoint group

  5. The managed node connectivity group captures the set of nodes that are going to participate in the management network

Correct Answer: CE


http://aci-troubleshooting-book.readthedocs.io/en/latest/mgmt_tn.html#fabric-management- routing

Question No.36

Refer to the exhibit. Your application has a reduced health score. Upon inspection, you find a fault that impacts the health score. The fault currently is in the soaking lifecycle stare. Which two options are possible next steps while in this state? (Choose two)


  1. Acknowledge the fault, which immediately clears it from the system

  2. Once the soaking timer expires the fault ceases and no change is expected in sevenity level.

  3. The condition ceases by itself and goes into the soaking-clearing state

  4. The condition ceases by itself and automatically clears the fault

  5. The soaking timer expires and moves to the Raised sevenity level

Correct Answer: CE

Question No.37

Which three LSA types are valid for OSPFv2? (Choose three)

  1. Router LSA: an LSA sent by every router. This LSA includes the state and the cost of all links and a list of all OSPFv2 neighbors on the link

  2. AS Internal LSA: an LSA generated by the ASBR. AS Internal LSAs are flooded only within the autonomous system

  3. Backbone Summary: an LSA sent by the backbone router to all the OSPF areas

  4. DR Summary LSA: an LSA sent by the DR router to all the others on network

  5. Default LSA: an LSA generated by the ASBR. These LSAs are used to propagate default route into OSPF

  6. Network LSA: an LSA sent by the DR. This LSA lists all routers in the multi-access network

  7. Opaque LSA: an LSA used to extend OSPF

Correct Answer: AFG

Question No.38

Which option is required by atomic counters to be leveraged in troubleshooting endpoint connectivity?

  1. Endpoints must be in different endpoint groups

  2. Endpoints must connect to different leaf switches

  3. Endpoints must connect to the same leaf switch

  4. Endpoints must be in different VRFs

  5. Endpoints must be in different bridge domains

Correct Answer: B

Question No.39

In which default state are all Cisco UCS Fabric Interconnect Ethernet ports configured?

  1. uplink port

  2. unconfigured port

  3. disabled port

  4. trunk port

  5. access port

Correct Answer: B

Explanation: https://www.cisco.com/en/US/docs/unified_computing/ucs/sw/gui/config/guide/141/UCSM_GUI_C onfiguration_Guide_141_chapter5.html

Question No.40

Which three statements are considered best practice when directly connecting converged network adapters to the fabric? (Choose three)

  1. Cisco Unified Fabric links must be configured as access ports and FCoE VLAN must not be configured as a native VLAN

  2. If MSTP is enabled, a separate MST instance must be used for FCoE VLANs

  3. Cisco UF links must be configured as spanning-tree edge ports

  4. A shared VLAN can be used to carry traffic for each virtual fabric in the SAN (for example, VLAN 1002 for VSAN 1, VSAN 2, and so on)

  5. Separate FCoE VLANs must be used for FCoE in SAN-A and SAN-B

  6. A blade switch must connect to multiple converged access switched in a topology.

Correct Answer: BCE

Get Full Version of the Exam
400-151 Dumps
400-151 VCE and PDF