Get Full Version of the Exam
http://www.EnsurePass.com/640-692.html
Question No.11
What is the default operating mode you are initially logging into a router?
-
global configuration
-
privileged EXEC
-
ROM monitor
-
user EXEC
Correct Answer: D
Question No.12
What one of the feature is associated with single-mode fiber-optic cable?
-
a single strand of glass fiber
-
stored less bandwidth
-
cost is less than multimode fiber
-
operates over less distance than multimode fiber
Correct Answer: A
Question No.13
Which two of the following are component of WAN connection? (Choose two)
-
router
-
switch
-
CSU/DSU
-
Hub
-
Bridge
Correct Answer: AC
Question No.14
When using a modem to provide out-of-band access to a Cisco router, which cable type is used to connect the wall jack to the modem?
-
DB-25 to RJ-11
-
RJ-11 to Rj-11
-
RJ-45 to RJ-45
-
RJ-11 to RJ-45
-
RJ-11 to DB-9
Correct Answer: B
Question No.15
Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? (Choose two.)
-
Router1 has specific boot system commands that instruct it to load IOS from a TFTP server.
-
Router1 is acting as a TFTP server for other routers.
-
Router1 cannot locate a valid IOS image in flash memory.
-
Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.
-
Cisco routers will first attempt to load an image from TFTP for management purposes.
Correct Answer: AC
Question No.16
Which statement about unique local IP addresses is true?
-
Summarization is not supported.
-
They require all prefixes to be unique.
-
Their global IDs are assigned sequentially.
-
They are routable to the public Internet.
-
Correct Answer: B
Question No.17
Refer to the exhibit. What does the CD LED indicate on the voice WAN interface card?
-
An alarm condition
-
Receive signal strength
-
A carrier has been detected
-
The interface is in loopback mode
Correct Answer: C
Question No.18
Which sequence begins a unique local IP address in binary notation?
A. |
1111110 |
B. |
1111111 |
C. |
00000000 |
D. |
1111100 |
Correct Answer: A
Question No.19
Which two commands are used to set the configuration register value? (Choose two)
-
Router(config)#config-register 0x2102
-
Router(config)#confreg 0x2102
-
rommongt;config-register 0x2102
-
rommongt;confreg 0x2102
-
Router(config)#configuration-register 0x2102
Correct Answer: AD
Question No.20
The pins and RJ-45 are numbered from 1 through 8. With the material points of the plug facing
toward you, pin 1 is the leftmost pin. Which two sets are looped on an RJ-45 T1 loopback plug? (Choose two)
-
Pins 1 and 4
-
Pins 1 and 7
-
Pins 2 and 5
-
Pins 2 and 8
-
Pins 1 and 5
-
Pins 2 and 7